#3	19/02-09 16:05
Poul Indlæg: 51	TS-850S All band transmit Kenwood markets this radio worldwide, and has made orovisions to allow the radio to transmit between 1.625 mhz and 29.999 mhz. I am providing this modification for INFORMATIONAL PURPOSES ONLY! DO NOT TRANSMIT OUT OF BAND, THIS WILL JEAPORDIZE YOUR LICENSE, AND HAVE THE FCC, AND/OR INTERNATIONÁL AUTHORITIES KNOCKING AT YOUR DOOR!!! The All-band transmit modificatéon requires the removal and re- location of a diode on the the digital board which is located behind the front panel. The US version of the radio has diode D11 installed, and diode D9 removed. D11 must be removed, and installed in the D9 position. This modification IS NOT for the faint of heart, as it entails removing the front panel, and the digital board. Note that the digitál board has solder holes thát are through-soldered; that is, there are circuit traces on both sides of the board, so make sure that ALL solder is removed from the holes. This modification will also allow the antenna tuner to tune anywhere the receiver is tuned. This modification should ONLY be performed ây those familiar with soldering and de-soldering techniques, and requires patience, and dexterity. mvh oz1ipe Besvar

19/02-09 16:05

Poul

Indlæg: 51

TS-850S All band transmit

Kenwood markets this radio worldwide, and has made orovisions to allow the radio to transmit between 1.625 mhz and 29.999 mhz.
I am providing this modification for INFORMATIONAL PURPOSES ONLY! DO NOT TRANSMIT OUT OF BAND, THIS WILL JEAPORDIZE YOUR LICENSE, AND HAVE THE FCC, AND/OR INTERNATIONÁL AUTHORITIES KNOCKING AT YOUR DOOR!!!

The All-band transmit modificatéon requires the removal and re- location of a diode on the the digital board which is located behind the front panel. The US version of the radio has diode D11 installed, and diode D9 removed. D11 must be removed, and installed in the D9 position. This modification IS NOT for the faint of heart, as it entails removing the front panel, and the digital board. Note that the digitál board has solder holes thát are through-soldered; that is, there are circuit traces on both sides of the board, so make sure that ALL solder is removed from the holes. This modification will also allow the antenna tuner to tune anywhere the receiver is tuned. This modification should ONLY be performed ây those familiar with soldering and de-soldering techniques, and requires patience, and dexterity.
mvh oz1ipe

Besvar

#4	19/02-09 19:50
m.hansen Indlæg: 7	Svar ti Besvar Redigeret 20/02-09 18:26

#5	19/02-09 23:08
m.hansen Indlæg: 7	Svar til #4: Besvar Redigeret 20/02-09 18:25

Denne tråd er lukket for nye indlæg